Setting Up Your LDS-02 Door Sensor: A Step-by-Step Guide
This article is designed to help customers who have received their Dragino LDS02 door sensors. If you have received a different type of sensor, please reach out to support@connectedfresh.com for the best setup instructions for your device. Let's get set up!
Unpacking Your Box
Your Dragino LDS02 door sensor box will come with the following components:
- 1x door sensor
- 2x AAA batteries (if applicable)
- Mounting hardware (screws or mounting tape)
Setting up the Door Sensor
Step 1: Insert batteries (if required)
If your sensor is housed inside of a black box with an external antenna, you may skip this step.
After removing the cover, place 2x AAA batteries inside of the door sensor. An LED will flash on the front of the unit, it is now in activation mode with the gateway. The LED will show solid green for a few seconds when it successfully authenticates. After that, it is ready to go.
If you need any assistance with this part, please reach out to support@connectedfresh.com.
Step 2: Mount the Sensor
The Dragino LDS02 door sensor can be mounted on the door frame or door itself, depending on your preference. Use the provided mounting hardware to secure the sensor in place.
Step 3: Verify Connection to Gateway
The door sensor will communicate with the gateway over LoRaWAN. Verify that the door sensor is properly communicating with the gateway by checking the status indicator on the sensor. A solid green LED light indicates that the sensor is connected to the gateway and working properly.
Step 4: Monitor Door Status
The door sensor will send door open/close status updates to the gateway. You can monitor the status of your doors in real-time using the ConnectedFresh dashboard (my.connectedfresh.com).
If you have any questions or need assistance with setting up your Dragino LDS02 door sensor, please reach out to ConnectedFresh Support at support@connectedfresh.com.
Item Categories
Related Articles
Setting Up Your Milesight WS301 Magnetic Contact Switch (Small Door Sensor) : A Step-by-Step Guide
Welcome to the world of IoT and ConnectedFresh! This article will guide you through the process of setting up your Milesight WS301 Magnetic Contact Switch (Small Door Sensor). With just a few simple steps, you'll be up and running in no time. Let's ...Setting Up Your Milesight EM300 Magnetic Contact Switch Sensor: A Step-by-Step Guide
Welcome to the world of IoT and ConnectedFresh! This article will guide you through the process of setting up your EM300 Magnetic Contact Switch Sensor -- an alarming sensor for unauthorized entry in real-time. With just a few simple steps, you'll be ...Setting Up Your Dragino LHT65N/LHT65S Temperature Sensor: A Step-by-Step Guide
Welcome to the world of IoT and ConnectedFresh! This article will guide you through the process of setting up your Dragino LHT65S/LHT65N temperature sensor, which runs on the LoRaWAN network. With just a few simple steps, you'll be up and running in ...Setting Up Your Dragino LSN50-V2 - Waterproof Long Range Wireless LoRa Sensor: A Step-by-Step Guide
Welcome to the world of IoT and ConnectedFresh! This article will guide you through the process of setting up your Dragino LSN50-V2- Waterproof Long Range Wireless LoRa Sensor, which runs on the LoRaWAN network. With just a few simple steps, you'll ...Setting Up Your DS03A-LB/LS Outdoor LoRaWAN Door Sensor: A Step-by-Step Guide
Setting Up Your DS03A-LB/LS Outdoor LoRaWAN Door Sensor: A Step-by-Step Guide This article is designed to help customers who have received their DS03A-LB/LS Outdoor LoRaWAN Door Sensor. If you have received a different type of sensor, please reach ...